Our Products - Epoxy High Build MIO Paint
| TECHNICAL DATA SHEET |
| Product Description |
This is two pack cold cure High Build Epoxy Finish Paint cured with polyamine hardener . It has excellent
corrosion resistance in wide range of corrosive conditions. It also has good resistance to abrasion and impact. |
| Recommended Uses |
This product is used as a heavy duty intermediate or finishing coat for structural steel in Chemical, Fertilizer Plants, Power Plants etc. |
| PRODUCT SPECIFICATION |
| Mixing Ratio |
Base : Hardener
4 : 1 |
| Colour |
All Shades as per customer requirement. |
| Finish |
Semiglossy – Glossy |
| Pot Life |
4 – 5 hrs at 30 �C & 65 % Relative Humidity |
| Volume Solids |
60 % � 3 |
| Flash point |
More than 24 �C |
| Recommended DFT |
80 – 120 microns per coat |
| Covering Capacity |
5 to 8 sq.mtrs / ltr |
| (Theoretical) |
- |
| Drying Time |
Surface dry – 2 to 3 hrs at 30 �C & 65 % Relative Humidity
Hard Dry – 10 - 12 hrs max at 30 �C & 65 % Relative Humidity
Fully cured – 7 days |
| Recoating Time |
Min : 10 - 12 hrs. at 30 �C & 65 % Relative Humidity Max : 7 days |
| Method of Application |
Brush / Airless Spray |
| Thinner recommended |
' Epicor ’ Thinner |
| Shelf life |
12 months under normal storage conditions in original sealed containers. |
| Surface Preparation |
Suitably primed surface free from oil, grease, moisture and any other foreign matters. |
| Remarks 1. Application Data |
| Method |
Pressure ( Atm) |
Nozzle |
Thinner |
Thinner volume |
| Brush |
- |
- |
Epicor Thinner |
0 – 5 % |
| Airless Spray |
4 – 5 |
0.018 inch to 0.025 inch
|
Epicor Thinner |
0 – 5 % |
2. Don’t use below 10 �C
3. Stir well before and while using .
4. Film thickness other than indicated also possible.
5. Mix 15 mins before use.
| Safety Precautions : |
| Provide sufficient ventilation while working with solvent based paints in confined spaces and stagnant air. |
Keep the material away from heat , spark and direct flame |
| Avoid inhalation of solvent vapour or paint mist by using facial mask .Use goggles and gloves to protect against direct contact of paint with
skin and eyes. |
In case of contamination , rinse with fresh running water and seek medical help at once. |
| Follow local & national safety rules. |
| Special Comments : |
| Thinner consumption and actual coverage of paint depends on the site conditions. |
Stir the paint well before painting and while painting if necessary. |
| Material should be stored at 30 �C temperature in dry place.
|
